[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [TCML] Climbing Arcs
Hi Tony,
The video that David Rieben discussed in his latest post shows similar
"snappiness" to the arc.
http://www.youtube.com/watch?v=0dLTEOM3qQc
The higher voltages of X-ray transformers increases the effect of
parasitic capacitance on Jacobs Ladders, making them sound quite nasty
even without any other lumped C across the gap. A small HV cap across
the gap in an NST also helps raise the open circuit voltage, making it
easier to restart the arc at the base of the ladder. It's a bit harder
on the NST however.
Re: coins & Stuff - they are an oddity for sure. BTW, we'll be
appearing in an upcoming issue of Coin World Magazine, and our
Lichtenbergs are now on the cover of the latest Edmund Scientific catalog.
Do you still making Geissler tube replicas? The one you traded for is
still very beautiful!
Best wishes,
Bert
--
***************************************************
We specialize in UNIQUE items! Coins shrunk by huge
magnetic fields, Lichtenberg Figures (our "Captured
Lightning") and out of print technical Books. Visit
Stoneridge Engineering at http://www.teslamania.com
***************************************************
Sfxneon@xxxxxxx wrote:
Hello Bert,
Appreciate all the suggestions! I really like the one about using a small
capacitance across the secondary to add a little SNAP! I'll give it a try.
Do you still have that xenon plasma tube that I traded to you for the
shrunken coins? I still have the coins and they never fail to amaze people!
Thanks,
Tony
In a message dated 5/27/2008 10:04:02 A.M. Central Daylight Time,
bert.hickman@xxxxxxxxxx writes:
Hi Tony,
Some suggestions:
1. Use a wide "V" to more rapidly spread the arc. The higher the current
the wider the end gap should be
2. Use inductive ballasting for best performance
3. Use smooth rails to avoid incandescent "hot spots" that will cause
the arc roots to temporarily hang in one spot. I'd recommend using 3/4"
hard copper pipe or non-magnetic stainless steel tubing. Periodically
remove any oxide buildup. I suspect the oxidation of the galvanizing may
a major part of the problem you're seeing.
4. Enclose on 4 sides to reduce disruption by air currents. Leave top
AND bottom portion open to permit vertical air flow. Be sure to leave
plenty of clearance on either side of the gap, especially for a higher
current ladder.
5. For grins, try connecting a small (500 - 1000 pF) HV doorknob cap
across the gap to make for "snappier" performance at start and at long
arc lengths.
Good luck,
Bert
**************Get trade secrets for amazing burgers. Watch "Cooking with
Tyler Florence" on AOL Food.
(http://food.aol.com/tyler-florence?video=4&?NCID=aolfod00030000000002)
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla