[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: [TCML] Terry Filter MOV heat



The correct number of MOV's to use is governed by the NST voltage.  For a 15kV NST, 8 per side are needed.  With what voltage are you using 7?  Who is using 5?

Per Terry's original documentation:
NST     MOV's per side
9kV     6
12kV    7
15kV    8

Regards, Gary Lau
MA, USA

> -----Original Message-----
> From: tesla-bounces@xxxxxxxxxx [mailto:tesla-bounces@xxxxxxxxxx] On
> Behalf Of DC Cox
> Sent: Thursday, June 19, 2008 12:02 PM
> To: Tesla Coil Mailing List
> Subject: Re: [TCML] Terry Filter MOV heat
>
> Yes, but it's not good.  I alwys use 7 MOVs in each leg, not 5.  This seems
> to work and they don't run so hot.  Be sure to use the safety gap of course.
>
> Dr. Resonance
>
>
>
>
> On Thu, Jun 19, 2008 at 8:55 AM, Mark <mark@xxxxxxxxxxxxxxxx> wrote:
>
> > Hi,
> >
> > Quick question for someone I hope, I've just finished building my Terry
> > Filter and when setting the safety gap noticed the MOV's nearest the
> > ground rail get very hot, so hot you can't touch them, is this
> > normal ???
> >
> > Regards
> >
> > Mark
> >
> > _______________________________________________
> > Tesla mailing list
> > Tesla@xxxxxxxxxxxxxx
> > http://www.pupman.com/mailman/listinfo/tesla
> >
> _______________________________________________
> Tesla mailing list
> Tesla@xxxxxxxxxxxxxx
> http://www.pupman.com/mailman/listinfo/tesla
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla