[TCML] New Coil Pics

[MIKE BAILEY <m.bailey@xxxxxxxxxx>]

Just wanted to show some pics of my new coil , and to thank everyone on the list for answering my questions and offering me advice. I still need to build a toroid for it and a few other little things like a larger variac for one and some PFC caps . 
  the specs are
   
  6 MOT power supply, no ballast, I have built a slide choke but have not used it yet  
  MMC 100nF tank ( 216 CD942 caps) 
  ARSG (16 -1/4"brass electrodes on a 10 aluminum disk 2-1/4 brass stationary electrodes) 
  12" secondary 1000 turns awg18
  corona ring made from 4" aluminum duct
  Primary coil 12 turns of spring bronze weather stripping
  22 amp variac ( I run it around 30 amps ) 
  safety gap across outputs
  120 volt 60 amp input variac
   
  max arc from corona ring is about 5 feet to grounded rod , I have only been able to run it in my garage so far , maybe this weekend I will run it outside if the weather is nice and I get the topload done.
  Here is the link for the pics , any suggestions for improvement would be greatly appreciated
  Thanks again everyone http://www.geocities.com/m.bailey@xxxxxxxxxx/
   
  Mike Bailey
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla