Re: [TCML] I think I ruined my 6" secondary.

[bunnykiller <bunnikillr@xxxxxxx>]

hey Kris...

Instead of sanding my coil to develope raw spots, mine fell over against 
the sharp edge of the tool box leaving a couple of inches exposed. I 
used "Glyptol" to patch up the scratch and had no problems with the 
insulation issues. I must admit tho, the Glyptol fix job wasnt a 
"pretty" repair. The color differential looks out of place...

Scot D



Kris Grillo wrote:

> I hand wound a 6" acrylic form with 22 gauge a few months ago. It wasn't the greatest winding job I had ever done. There were a few turns that were a little loose, but over all, turned out pretty damn good for not building a jig. I started coating it with poly and once I got about 10 coats on it I noticed it was kind of getting a little rough from dust and whatnot, so I grabbed a piece of 400 grit sand paper and gave it a light once over and began coating it again. 

snip

_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla