Re: [TCML] Salient Pole Query

[G Hunter <dogbrain_39560@xxxxxxxxx>]

> I'll echo John's experience.  After converting
> about a half-dozen motors, the only thing to strive for is
> that your flats are the same width, and have a uniform
> angular spacing between them.   As far as precision, I used
> a 4.5" angle grinder, and they turned out fine using
> John's rule of thumb given above.
> 

How did you make the flats with an angle grinder?  Did you mount the grinder or the rotor in some sort of jig?  Did you try to balance the rotor, or does a small imbalance matter?

Cheers,

Greg


      
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla