Hey Matthew...you dont need to replace the tar... just "reset" it by heating the NST to a point where the tar melts and settles in to fill voids that may have developed during the initial pouring.
Scot D Matthew Nilles wrote:
Ah, thanks guys, a ray of hope. I was hoping to not have to buy a new NST. Ok, so am i replacing all the tar? I'm not clear on this. Is it any special tar, or would the hardware store carry it?<Tesla@xxxxxxxxxxxxxx> <http://www.pupman.com/mailman/listinfo/tesla>_______________________________________________ Tesla mailing list Tesla@xxxxxxxxxxxxxx http://www.pupman.com/mailman/listinfo/tesla
_______________________________________________ Tesla mailing list Tesla@xxxxxxxxxxxxxx http://www.pupman.com/mailman/listinfo/tesla