RE: [TCML] Secondary to toriod ?

["Jim Mora" <wavetuner@xxxxxxxxx>]

Hey, I agree! It must be a bitch to tap say acrylics or Polycarbonate walls,
My preferred formers.  I drill a tapped .5 " hole top and bottom .25" plate
connected with Ace Hardware fast dry clear epoxy! This allows to blow or
vacuum the vapors out of the inside the coil. I use a circle cutter to cut
accurate end plates up to 8" the torrid or the base can be very heavily
connected with.5 inch nylon all thread for adjustment. Works for me:-) This
included inncluding PVC. The Base of the coil is made with a short length of
close fitting PVC to hold it thoroughly making easy adjustment and strong
holding of the adjustment of the secondary penetration.

Jim Mora

-----Original Message-----
From: tesla-bounces@xxxxxxxxxx [mailto:tesla-bounces@xxxxxxxxxx] On Behalf
Of Tesla
Sent: Sunday, August 24, 2008 9:47 PM
To: Tesla Coil Mailing List
Subject: Re: [TCML] Secondary to toriod ?

At 18:39 2008-08-24, you wrote:
>Hi all,
>
[snip]

I simply use nylon screws for everything that goes on top of the 
coil. I really don't like
to introduce any more or less sharp metal object at the top. Except 
the toroid of course.
Small nylon screws for the cap etc and a bigger one to secure the toroid.

/Matt 

_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla

_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla