[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [TCML] Secondary to toriod ?



Hi Stan,

If there is no metal attaching the bottom of the coil or its receptacle to the base, then the chances of internal arcing are reduced. The relatively small radius of curvature of a bolt head could cause it to act like an internal breakout point, encouraging internal arcing. A heavy glop of insulating material on the bolt head and/or a well-sealed baffle inside the top of the secondary form would eliminate any problem. Over the years, some people have run successfully with little or no protection over bolts, etc. It's a matter of more likely to have problems vs less likely to have problems, and your comfort level and ability to afford the recovery
from an "Oh S***" event. ;^}


Matt D.


-----Original Message-----
From: stanley miller <swm334@xxxxxxxxx>
To: tesla@xxxxxxxxxx
Sent: Sun, 24 Aug 2008 12:39 pm
Subject: [TCML] Secondary to toriod ?



Hi all,
 
I am wondering if anyone could explain why a zinc carriage bolt inserted into the center of a plastic cover, glued on top of the secondary, with the bolt head inside covered by a plastic cap would not work or be potentially dangerous.  This would allow the toriod to be completly adjustable, limited only by the size of the bolt.  I have never seen a TC with this sort of setup, it is always with
standoffs or pvc piping rigged up in some way or something else.
Please correct me w
here my theory is wrong.
 
-If the secondary cover sits 1.5" to 2" inches above the last winding on the secondary the only thing that could still affect the bolt would be magnetic field which i do not see how it would hurt the bolt or shunt it in anyway.
 
-Since the toriod would be at the same potential as bolt there would be no fear
of arcing to it.
 
-The bottom inside of secondary would have nothing metal to arc thru from top to
bottom.
 
-since toriod capacitance is dependent on size wouldn't the bolt add a small
amount to the overall capacitance of toriod
 
-I am embarassed to say i have an electrical degree and work in electronic field and am asking such a silly question.  ( but i do not pretend to know anything
about tesla coils or high voltage for that matter!)
 
Thank ya all!
Stan 
   



_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla

_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla