[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [TCML] Primary Tap connector



Hi Steve,

These are snap-in supports using 3/8" thick Plexiglas. The first time I tried snap-in standoffs, I made a mess of things with a sloppy hole depth which really dented and messed up the tubing. Acrylic is hard and will not flex. The tubing is what actually dents as the tubing is pushed in. I ended up buying another roll of 1/4" tubing and tried with new standoffs. To add a slight flex to the snap and prevent tube denting, I cut slots into the standoffs like this:
http://www.classictesla.com/temp/Pristand.gif

I only went about half as deep as the image shows, but you get the idea.

Regards,
Bart


steve date wrote:
Hi Bart,

Question, How are the "turns" attached to the supports? It appears they might snap in, or is there another clip or something?

The whole primary looks very neat!

Thanx,   steve - seattle
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla