[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [TCML] SISG heating at high freqencies



This coil was at 280kHz and no odd heating problems were noticed:

http://drsstc.com/~piranha/p-1/stuff/SmallSISGCoil.pdf

Maybe something else is wrong.

Terry




Peter Terren wrote:
I was playing with a 4 segment SISG with a 4 inch coil about 8 inches tall and 0.06 uF cap. Primary of 2 turns from a ballasted MOT (half wave rectified) and no toroid. Frequency would have been quite high >2-300kHz or even more. I was just messing around with the threshold voltages for curiosity and was using 3 of the 4 segments to get 1 inch sparks.

I was quite surprised to find that the SIDAC's were scorching hot and the IGBT's were uncomfortably hot, particularly one of them after a very short run. Considering that these have been used by others on a pole pig with only mild heating, that surprised me. It sounds like they had some frequency dependent problem because the SISG works OK (ie cold) with more primary inductance/capacitance. Beats me why the SIDAC's were getting hot though. Perhaps the IGBT's weren't turning on fast or fully so the SIDAC's spend more of the time conducting throughout the cycle relatively. Perhaps a lower gate resistor may have helped (I was using 100 ohms). I was planning to use a smaller 4 stage SISG for a demo mini coil but would have to sort out the frequency issues first.

Peter
www.tesladownunder.com

_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla



_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla