[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [TCML] Phase
Hi Tony,
Keep the motor off, but keep the electrodes aligned, see if the tank volts
gets high enough to jump the gap. If it does then make the gap wider and
keep going. Then you need to physically move the sync motor while it is
running. The spark gap should only fire within a few degrees of manual
adjustment. mark the points from left to right where the spark gap stops
conducting then you have your centre point which will be the top of the AC
cycle. You can then adjust your gaps wider if needs be once you have worked
out your gap fire.
If your gap does not fire while the motor is running then just close them
down a fraction and try again..
Hope this helps..
Chris
----- Original Message -----
From: <penny831@xxxxxxxxxxxxx>
To: "Tesla Coil Mailing List" <tesla@xxxxxxxxxx>
Sent: Wednesday, November 28, 2007 4:18 PM
Subject: [TCML] Phase
Good morning all,
I was wondering if anyone has any advise on presetting the phase on a
SRSG? I'd like to set it right in the begining for maximum bang for my
buck. I read about using a flurescent light but I could see anything when
I tied that besides a spinning electrode. Your advise is appreciated.
Tony
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla
--
No virus found in this incoming message.
Checked by AVG Free Edition.
Version: 7.5.503 / Virus Database: 269.16.8/1153 - Release Date:
26/11/2007 21:08
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla