Re: [TCML] Nee recommendation for a SRSG motor arbor

[johnbrooks@xxxxxxxxxxx]

This might work. (faceplate)
E-Bay  Item number: 120181450146
	
On Thu, 22 Nov 2007 21:55:06 -0800 (PST), "C. Sibley"
<a37chevy@xxxxxxxxx> said:
> I'm in the process of building up a big SRSG.  I've machined flats into
> the a 1800 RPM 3/4 HP motor and it is running nice and synchronous.  I'm
> cutting a disk from G11 Fiberglass, but need to figure a convenient way
> to attach it to the 5/8" shaft.  
>  
> The arbors I have been able to find are designed to adapt a motor to a
> buffing/grinding wheel.  It seems to me that this would be inadequate
> since the disk could spin at start-up.
>  
> Anyone have any recommendations for a good "off the shelf" solution?
>  
> Thanks,
>  
> Curt.
> 
> 
>       ____________________________________________________________________________________
> Never miss a thing.  Make Yahoo your home page. 
> http://www.yahoo.com/r/hs
> _______________________________________________
> Tesla mailing list
> Tesla@xxxxxxxxxxxxxx
> http://www.pupman.com/mailman/listinfo/tesla
-- 
  
  johnbrooks@xxxxxxxxxxx

-- 
http://www.fastmail.fm - IMAP accessible web-mail

_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla