RE: [PHISH] (fwd)

["Tesla list" <tesla@xxxxxxxxxx>]

Original poster: List moderator <mod1@xxxxxxxxxx>



---------- Forwarded message ----------
Date: Mon, 14 May 2007 19:16:20 -0700
From: Jim Mora <jmora@xxxxxxxxxxx>
To: 'Tesla list' <tesla@xxxxxxxxxx>
Subject: RE: [PHISH]

Sorry, came form my Isp's Iprism content checker. I should have deleted it
before replying.

Jim Mora

-----Original Message-----
From: Tesla list [mailto:tesla@xxxxxxxxxx] 
Sent: Monday, May 14, 2007 4:13 PM
To: tesla@xxxxxxxxxx
Subject: RE: [PHISH] RE: Teletype motor (fwd)

Original poster: List moderator <mod1@xxxxxxxxxx>



---------- Forwarded message ----------
Date: Mon, 14 May 2007 09:30:48 -0400
From: "Lau, Gary" <Gary.Lau@xxxxxx>
To: Tesla list <tesla@xxxxxxxxxx>
Subject: RE: [PHISH] RE: Teletype motor (fwd)

Regarding ways to make the motor mount adjustable to permit phase
adjustment, John Freau's electronic phase adjuster makes that completely
unnecessary.  All you need is a small Variac and a motor run capacitor.
For my Teletype motor I used a 2 Amp Variac and a 40uF run cap.  Photos
& schematic at http://www.laushaus.com/tesla/sync_gap.htm

How did [PHISH] get into the subject line?

Regards, Gary Lau
MA, USA

> Date: Wed, 9 May 2007 23:35:40 -0700
> From: Anthony R. Mollner <penny831@xxxxxxxxxxxxx>
> To: Tesla list <tesla@xxxxxxxxxx>
> Subject: RE: [PHISH] RE: Teletype motor
> 
> I have a head start on that. I have turned a piece of electrical grade
> polyester to make a balanced hub with a .125 thoriated tungsten rod (I
hope
> not to hear about the "dangers" of thorium again from the group) as
the
> propeller. It's set with Allen head set screws and spins perfectly.
The
> enclosure is acrylic plastic with a lexan face, for safety, and the
motor
> will eventually be mounted to .250 electrical grade fiberglass sheet.
I'm at
> the point that I need to build some kind of motor mount for the thing.
I've
> see many designs for the mount but I'm not sure at this point what to
make.
> I must be able to be adjustable to set the phase and that's my newest
> problem. Any advice?
> Tony