Dual MOT plans (was:Re: screw in tungsten-molydenum alloy electrodes for RSGs)

["Tesla list" <tesla@xxxxxxxxxx>]

Original poster: "Daniel Kline" <daniel_kline@xxxxxxxxxxx>

Hi Dr. R.
I would like to request a set of the dual-MOT plans mentioned below.
Would it be possible to run on one MOT for lowered output?
Thanks,
Dan K.

Tesla list wrote:
> Original poster: "resonance" <resonance@xxxxxxxxxxxx>
> The best route for an experimenter than can live with 7.5 to 8 ft 
> long sparks is our dual MOT design.  Matching dual MOTs can be 
> obtained direct from AMPI.com for $100 each and the SISG boards are 
> inexpensively available from Mark Dunn.  I give away the dual MOT 
> plans on off-list request.  It's a great coil, highly portable, easy 
> to set up, and most important --- I did the design so it would 
> operate from two separate 120 VAC circuits, each circuit driving a 
> single MOT at 16-18 Amps.  220 VAC not required for 7.5 to 8 ft long sparks.