RE: [TCML] capacitors

["Terry Oxandale" <Toxandale@xxxxxxx>]

How can a correction be made to the polypropylene capacitor reference
list:
http://hot-streamer.com/TeslaCoils/MMCInfo/good-bad.txt

G.E.		42L4102		3000		0.01

The capacitance value is erroneous in that it should be .10 rather than
.01 uF. I found no "contact" information on Terry's site with which to
send an email on the error.

(un)Terry



-----Original Message-----
From: tesla-bounces@xxxxxxxxxx [mailto:tesla-bounces@xxxxxxxxxx] On
Behalf Of Tom Trevethan
Sent: Monday, December 03, 2007 12:50 PM
To: tesla@xxxxxxxxxx
Subject: Re: [TCML] capacitors

Hi,

That's a big MMC - 200J per bang - IIRC about the same size as the one 
used for
Electrum. What power are you planning to run at?

There is a useful list of good polypropylene capacitors for tesla coil 
use here:
http://hot-streamer.com/TeslaCoils/MMCInfo/good-bad.txt

The Cornel Dubilier 942C20P15K (150nF, 2000V) seems to be very popular,
and I
have seen them advertised for $3-4 each. You would need 20 x 34 = 680
(approx
$2000).

Tom.

Quoting Tomas Stankevic <Tomas.Stankevic@xxxxxxxx>:

> Hi,
> what capacitors would you recommend me to build a 250nF @ 40kV MMC?
(for=20
> DC TC powered by 3phase pig) how much (approximately) it will cost?
What=20
> about shipping to Lithuania?
>
> Toma=9A
>
>
> _______________________________________________
> Tesla mailing list
> Tesla@xxxxxxxxxxxxxx
> http://www.pupman.com/mailman/listinfo/tesla
>

_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla