Re: [TCML] Q

["resonance" <resonance@xxxxxxxxxxxx>]

Richard's system used a reasonably high resistance sec coil --- wound with 
#28 AWG so Q isn't the best, but it still produced 11 ft long sparks on only 
9 kVA input power which is a record.  This is a magnifier type coil system.

Dr. Resonance

Resonance Research Corp.
www.resonanceresearch.com


----- Original Message ----- 
From: "Antonio Carlos M. de Queiroz" <acmdq@xxxxxxxxxx>
To: "Tesla Coil Mailing List" <tesla@xxxxxxxxxx>
Sent: Saturday, December 01, 2007 8:08 AM
Subject: Re: [TCML] Q


> resonance wrote:
> > It's the primary Q that must be high.  Richard Hull proved long ago that 
> > even a small "resonator" coil in a 3 coil system, the resonator was 
> > approx 4 inches x 34 inches, and was producing 11 ft long sparks, so the 
> > Q factor of the sec coil is really not that important.
> >
> > Rich is not active on the list but I think Dave Sharpe may have some of 
> > this data.
> An analysis of the linearized system shows that the effects of primary and 
> secondary Qs are exactly the same. For example, a system with primary Q = 
> 100 and a lossless secondary and another system with a lossless primary 
> and a secondary with Q=100 produce the same output waveform. This is also 
> valid for any other combination of Qs.
>
> Antonio Carlos M. de Queiroz
>
> _______________________________________________
> Tesla mailing list
> Tesla@xxxxxxxxxxxxxx
> http://www.pupman.com/mailman/listinfo/tesla


_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla