[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Repotting NSTs



Original poster: "Barton B. Anderson" <bartb@xxxxxxxxxxxxxxxx>

Hi Jonathan,

I repotted a 12/60 NST a while back and documented my experience;
http://www.classictesla.com/photos/nstrepair/nstrepair.htm

As far as using paraffin wax, I had no problems at all. I found it was a perfect potting compound for reasons shown in the document (a mishap where I had to remelt the wax and pull the core back out). There are pics in the document above showing the paraffin wax. I chose the wax over the jelly because I wanted a solid potting compound around the core in the case.

Take care,
Bart

Tesla list wrote:

Original poster: "Jonathan Peakall" <jpeakall@xxxxxxxxxxxx>

Hi All,

Well, I finally destroyed an NST. I wouldn't worry about it, except that it
is a 12/120, and the 120's are rare. I was using it to power a Marx bank. I
get full spark from one side and a wimpy spark from the other. The good side
reades a few ohms higher than the bad side, which is probably how it was
before. This makes me believe that the cause is carbon tracking.

So yesterday I melted the tar. It was quite easy. I used an old metal pot,
the kind used for canning. I cut a hole in the side large enough to fit the
barrel of my heat gun in there. Put some old clothes on and around the pot
for insulation. Took a few hours to melt the tar, but very little stink and
low chance of fire. Anyway...

I let it cool, and while it seems a little improved, it is not fixed. So I
have to empty the NST of tar, use solvent to clean it, and then I want to
repot it. I don't want to use oil. This NST is going to get moved around,
going to school and so on. I don't want to be dragging around a leaky oily
mess.

I have concenrns about re-using the tar. First, it will be hard to keep it
perfectly clean. And then there is going to be some loss of tar, so even if
I tried to save it I might not have enough. Anyone know where to buy such
tar?

I am assuming that the NST must be potted. Can they be run dry?

Many thanks,

Jonathan
www.madlabs.info