RE: pvc pipe thickness.

["Tesla list" <tesla@xxxxxxxxxx>]

Original poster: "Lau, Gary" <Gary.Lau@xxxxxx>

I've always just coated the finished, wound coil, since the poly is thin
enough to soak through the winding to the PVC.  No doubt others will
have varying opinions.

Regards, Gary Lau
MA, USA

> Original poster: John <guipenguin@xxxxxxxxx>
>
> Thanks.
>
> Should the PVC pipe be coted with poly before AND on top of the coil?
> or just after?
>
> On 10/5/06, Tesla list <<mailto:tesla@xxxxxxxxxx> tesla@xxxxxxxxxx>
wrote:
> Original poster: "Lau, Gary" <<mailto:Gary.Lau@xxxxxx>
Gary.Lau@xxxxxx>
>
> The only down side to what you have is that it will be heavier than a
> thinner pipe.  But functionally speaking, this shouldn't matter.
>
> Regards, Gary Lau
> MA, USA
>
>
>  > Original poster: John <
> <mailto:guipenguin@xxxxxxxxx>guipenguin@xxxxxxxxx>
>  >
>  > I need a 4" diameter pvc pipe for my current coil spec.
>  >
>  > I got a cut off which has a thickness of about 1/4 an inch. Is this
> too thick?
>  >
>
>
>
>