[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Parallizing...

Original poster: "David Rieben" <drieben@xxxxxxxxxxxxxxx>

Hi Chip,

Assuming that each of your 3 variacs in your
"triple-stack" varaic are all rated for 240 volts
in/ 240/280 volts out, then your hookup is correct
for 240 volts in/ 0-240 volts out. If you would
like to have 0-280 volts output, then simply
change the green "110 V. L2" hookup to each
variac from the pin 4 to pin 2.

David Rieben

----- Original Message -----
From: "Tesla list" <tesla@xxxxxxxxxx>
To: <tesla@xxxxxxxxxx>
Sent: Friday, November 24, 2006 2:53 PM
Subject: Parallizing...


> Original poster: "Chip Ford" <chipford@xxxxxxxxxxxx>
>
> O.K. guys. I have a 15amp/section (3) Phase Variac. If I wanted to
> run all three of these in parallel, would the attached schematic be
> correct....thanks chip
>
> http://hot-streamer.com/temp/Parallized2.JPG
>
>
>