Original poster: Finn Hammer <f-h@xxxx>
One great thing about being a seasoned member of this fine
brotherhood of high voltage pulsed engineers is, that if the recipe
starts with:
"You take an OLTC", well then I can go to the shed and drag out an
old battered prototype.
And when the recipe continues:
"Then sprinkle with SISG topping", then I have recent experience
with that too.
Ok, Enough hand waving.
The guts of the product, the Off Line BRIck siSG Tesla Coil, can be seen here:
http://home5.inet.tele.dk/f-hammer/guts.jpg
To get the gate of the CM600 open, I used a 36V TVZ, a 200nF cap a
5Ohm Gate charging resistor and a 750ohm gate discharge resistor.
The result can be seen here:
http://home5.inet.tele.dk/f-hammer/gatestuff.jpg
Resonant charging as usual,
http://home5.inet.tele.dk/f-hammer/resch.jpg
Does it make sparks, oh yes! And this coil is one that appears to
favour high break rates as seen on this short video, where I sweep
from 63BPS to 1250BPS
http://www.sharebigfile.com/file/22108/MOV00634.mpg.html
Cheers, Finn Hammer