[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Introduction - New TC

Original poster: FutureT@xxxxxxx In a message dated 5/30/06 11:39:42 AM Eastern Daylight Time, tesla@xxxxxxxxxx writes: 



I was planning
to make a toroid from dryer duct, but it looks like there's someone here
who sells spun toroids, I might have to go that route.  Sizes? Current
prices?



Doug,

I use a 4" x 13" spun aluminum toroid for my TT-42 Tesla coil which
can be seen at my website.  I use a 12/30 NST.  I make and sell
the spun toroids.  Info below.
---------

I have three sizes of professional quality spun aluminum toroids available.
All sizes have 1/4" mounting hole.

Spun toroids permit the sparks to glide over the toroid surface, and
longer sparks can be obtained for a given toroid diameter compared
with corregated dryer duct toroids.  Spun toroids give a tesla coil
a professional finishing touch.  They are the "gold-standard" in topload
excellence.

All prices include shipping within the USA, so they are the total prices.
Immediate shipment by priority mail.

   1.75" x 6" ................. spin polish.................  $44

   4" x 13"  ........ pristine brushed finish .......... $139

   5" x 16"  ........ pristine brushed finish .......... $182


      http://hometown.aol.com/futuret/page1.html

Payment by PayPal (FutureT@xxxxxxx), MO, or check.

John Freau
49 Thiem Ave
Rochelle Pk,  NJ   07662


Thanks,
John