Re: Grinding flats into motor to make syncronous help!

["Tesla list" <tesla@xxxxxxxxxx>]

Original poster: "Gerry  Reynolds" <gerryreynolds@xxxxxxxxxxxxx>

Hi Terry,

Regarding Aarons motor picture, which windings are the run 
windings?  Are they always the inside windings,  the windings with 
the heavier guage (the guages look the same here), or the windings 
with the most number of turns??


> Here is a picture of the motor:
>
> http://theflyingbullet.com/motor/IMG_1769.JPG

If I assume the run windings are the copper ones, would the dead pole 
be between the windings of one pole and the windings of an adjacent 
pole (red tick area) or in the region of no windings (peak of the 
pole in the blue area. If in the red tick area, is it the distance 
between the left and right red ticks?  Or should it be measured from 
the center of the right most bunch of windings on the pole left of 
the red ticks to the center of the left most bunch of windings on the 
pole right of the red ticks??

Gerry R.