Re: twin stacked primary supports

["Tesla list" <tesla@xxxxxxxxxx>]

Original poster: "Mike Tucknott" <michael.tucknott@xxxxxxxxxx>


Hi Bob

I did look at building the coil supports so that the bottom coil wound
inwards
and the top wound outwards but I just could not get my head round to where
the holes needed too be drilled.

Cheers Mike


> Original poster: "Bob (R.A.) Jones" <a1accounting@xxxxxxxxxxxxx>
>
> Hi,
>
> You could wind the coil two turns at a time. If that makes sense, just
like
> a transformer but only two turns in each layer.
> The problem may be how to get from one turn to the next turn and from one
> layer to the next layer.
> Working out how to drill the supports to wind it that way smoothly would
be
> tricky especially for a conical.
> I guess the holes would have to spiral out and zig zag up and down at the
> same time.
>
>