Re: Setting up a pole pig's wiring

["Tesla list" <tesla@xxxxxxxxxx>]

Original poster: Yurtle Turtle <yurtle_t@xxxxxxxxx>

Sounds like there isn't any consistancy with pig LV
designation. Dr. R's use X1 and X2, mine uses X1 and
X3, with X2 being neutral, and Gerry stated his were
all simply X.

http://www.hot-streamer.com/adam/garage/pig_14.4kV_25kVA_3.jpg

Adam

--- Tesla list <tesla@xxxxxxxxxx> wrote:

> Original poster: "D.C. Cox" <resonance@xxxxxxxxxx>
>
>
> Pole xmfrs typically used X1 and X2 for the 220 volt
> side and
> designate H1 and H2 on the 14.4 kV side.
>

>Original poster: "Gerry  Reynolds"
><gerryreynolds@xxxxxxxxxxxxx>
>
>The LV side of my pig nameplate shows two coils,
>where each coil is
>internally wired in parallel for 120V operation or
>internally wired
>in series for 240V operation.  All LV nodes are
>labled as X; not X0,
>X1, nor X2.