Original poster: "Barton B. Anderson" <bartb@xxxxxxxxxxxxxxxx>
Not a bad idea Curt. Cost is proportional to board size and the
spacing required would make it expensive. A possible solution to
keeping the board at minimal cost (small) while also enhancing the
spacing requirements is to make a single side only (single side of
the Terry Filter), then just use 2. This would eliminate unused
board space between components and would also allow for individual
mounting (spacing is then set by proximity of the 2 boards and
easily managed by your own mounting and placement).
Take care,
Bart
Tesla list wrote:
Original poster: "C. Sibley" <a37chevy@xxxxxxxxx>
Does anyone have any experience with building a NST
protection filter on a printed circuit board? I just
became aware of http://www.expresspcb.com and thought
maybe I'd give it a try. Seems as though the HV
wouldn't be a problem if you kept it single layer and
allowed adequate spacing.
Thoughts?
Curt.