[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Question on Ceiling Height/Material

To: tesla@xxxxxxxxxx
Subject: Re: Question on Ceiling Height/Material
From: "Tesla list" <tesla@xxxxxxxxxx>
Date: Mon, 19 Jun 2006 07:01:27 -0600
Delivered-to: testla@xxxxxxxxxx
Delivered-to: tesla@xxxxxxxxxx
Old-return-path: <vardan01@xxxxxxxxxxxxxxxxxxxxxxx>
Resent-date: Mon, 19 Jun 2006 07:01:36 -0600 (MDT)
Resent-from: tesla@xxxxxxxxxx
Resent-message-id: <CGF0LP4sdzI.A.LYG.wAqlEB@chip1>
Resent-sender: tesla-request@xxxxxxxxxx

Original poster: Mddeming@xxxxxxxIn a message dated 6/19/06 12:57:46 A.M. Eastern Daylight Time,tesla@xxxxxxxxxx writes:

can been seen in this set of data, the JAVATC is right on in most
instances. As Bart mentions, for my garage I will have to come up
with a little correction factor due to the rafters and roof angle.

Regards,
Jim Zimmerschied

Hi Jim,

You may also find that, due to the angles, etc., the "garage heightcorrection factor" will vary with where in the room the coil islocated and may also vary with different height coils.


Matt D.

Prev by Date: Re: Question on Ceiling Height/Material
Next by Date: Tesla 150th celebrations in Australia
Previous by thread: Re: Question on Ceiling Height/Material
Next by thread: Re: Question on Ceiling Height/Material
Index(es):
- Date
- Thread