Original poster: tesla <tesla@xxxxxxxxxxxxxxx>
Hi Mike
As SMPS were wrecked for parts (and one given to fellow coiler for
investigations) cannot operate as completed unit this time.
Dia of Litz Primary wire strands is 0.2mm.
Will keep future supplies intact for experimentation as completed units.
Notes some ideas about using these as a source for DC resoonant PSU and they
might have sufficienty isolation to put in series. Hope to find a schematic
some time to check ideas. In first instance it might be possible to remove
and reverse rectifiers on HV side and at least make a +/- supply. Anybody
wih schematics for typical MWO SMPS ??
Best
ted
> Original poster: "Mike" <mike.marcum@xxxxxxxxxxxx>
>
> can you tell what guage wire is used for the strands on the litz
> primary? Without a scope that can get you in the right city, but not
> sure about ballpark (eg: if it's 38 awg it's prob 50-100 kHz, thicker
>
> Mike