Original poster: "Scott Hanson" <huil888@xxxxxxxxxxxx>
DC -
Is something wrong with your cap calcs here?
Eight of the C-D 15uF 2KV caps in series will provide the specified
.0188uF value, but at a voltage rating of only 16KV.
Sixteen of the same caps in series will provide only .0094uF at a
more conservative 32KV.
What is your recommended value: .018uF, or .009uF?
Did you mean TWO parallel strings of 16 caps each?
Regards,
Scott Hanson
----- Original Message ----- From: "Tesla list" <tesla@xxxxxxxxxx>
To: <tesla@xxxxxxxxxx>
Sent: Sunday, June 11, 2006 11:17 PM
Subject: Re: wire lengnth
Original poster: "Dr. Resonance" <resonance@xxxxxxxxxx>
It should be noted that Terry's sample calculation is for a 4 inch
OD (outside dia.) tube. If you are using standard PVC schedule 40
water pipe (like Home Depot stuff) then the calculation would be
for 4.5 inch OD tubing with 1,000 turns and becomes:
sec wire length = (3.14159 x 4.5 x 1000 turns)/12
in/ft. = 1,178 feet of wire.
If you are using 24 AWG double-build 200 degree C. magnet wire then
the 1,000 turns would work out to a lineal winding length of 22.5
inches. Allow 3/4 inch on top and 3/4 inch on bottom of your tube
so tube length (total) before winding is 24 inches.
A .0188 uF 32 kV MMC cap design (16 pcs of 0.15 uF 2 kV MMC caps
in series) with a copper tube spark gap (200 CFM fan on each end
--- one pushing and one pulling air through a 6 inch dia. pvc tube)
will produce 58 inch long sparks with a 12/60 NST. Very compact
and good performance for a small portable coil. Be sure to use a
strike rail around the primary coil.
Dr. Resonance
----- Original Message ----- From: "Tesla list" <tesla@xxxxxxxxxx>
To: <tesla@xxxxxxxxxx>
Sent: Sunday, June 11, 2006 12:55 PM
Subject: Re: wire lengnth
Original poster: Vardan <vardan01@xxxxxxxxxxxxxxxxxxxxxxx>
Hi,
Today, the "length of the wire" has been found not to matter as
far as st....