Re: Tungsten Blanks

["Tesla list" <tesla@xxxxxxxxxx>]

Original poster: "Jon Danniken" <danniken@xxxxxxxxxxx>

That sounds like a great and worthwhile experiment, DC.  I'll be eager to
hear how this turns out (NPI).

Jon


> Original poster: "D.C. Cox" <resonance@xxxxxxxxxx>
>
>
>
> The 0.500 x 6 inch size in M-42 super high speed steel is priced at a
> reasonable $14.42.  I'm going to order a dozen of these, chop them up
> with our diamond disk cutter, and see how they work in one of our
> G-10 rotors. If they work good I will make them available to the list.
>
> Also, regarding the toroids, some members wanted a 24 x 6 inch size
> so we are going to see if we can mix the 20 x 5 size with the 24 x 6
> size to get good pricing on both sizes for our bulk order.  I will
> advise the list in a few weeks when I know.
>
> Dr. Resonance
>
>
>
> >Original poster: "Jon Danniken" <danniken@xxxxxxxxxxx>
> >
> > > Original poster: "MIKE HARDY" wrote:
> > >
> > > Earlier this summer there was a discussion on drill blanks for rotary
> > > electrodes. Someone pointed to a vendor that had 1 inch diameter X 8"
> > > tungsten drill blanks for about $100 each. Does anyone recall the
> > > vendor, and how to find this product?
> >
> >The only place I have found that has C2 Carbide Blanks at a price
comparable
> >to McMaster-Carr isWilliam T. Hutchinson, but they don't have the price
you
> >are looking for.
> >http://www.drillblank.com
> >
> >Jon
> >
> >
>
>
>