[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: Disassembling transformers

To: tesla@xxxxxxxxxx
Subject: RE: Disassembling transformers
From: "Tesla list" <tesla@xxxxxxxxxx>
Date: Thu, 09 Feb 2006 22:13:10 -0700
Delivered-to: testla@xxxxxxxxxx
Delivered-to: tesla@xxxxxxxxxx
Old-return-path: <vardan01@xxxxxxxxxxxxxxxxxxxxxxx>
Resent-date: Thu, 9 Feb 2006 22:04:49 -0700 (MST)
Resent-from: tesla@xxxxxxxxxx
Resent-message-id: <HmydZieXRRI.A.hAB.w7B7DB@chip1>
Resent-sender: tesla-request@xxxxxxxxxx

Original poster: "Robert Hanford" <pomnept@xxxxxxxxxxx>

Hi,
I froze my NST, chipped away some or the tar, then soaked it in gasoline til
almost all the tar was gone. Don't remove all of the shunts. There is good
internet material on this. I think a lot of us have stories about this
particular aspect of coiling.
Good luck,
Robert Hanford

-----Original Message-----
From: Tesla list [mailto:tesla@xxxxxxxxxx]
Sent: Thursday, February 09, 2006 10:38 PM
To: tesla@xxxxxxxxxx
Subject: Disassembling transformers

Original poster: norman@xxxxxxxxxxxxxxxxxxxxxxxxx

Has anyone tried to open up an OBIT or NST and dissolve the potting material
in
order to remove the magnetic shunts?  If so, could you explain how.

Prev by Date: Re: Toroid size on Big Coils
Next by Date: Re: Toroid size on Big Coils
Previous by thread: Disassembling transformers
Next by thread: Re: Disassembling transformers
Index(es):
- Date
- Thread