Original poster: "D.C. Cox" <resonance@xxxxxxxxxx>
If you plan to produce a spark length equal to
or greater than the coil length then use baffles
to preclude any chance of interior
flashover. No vents in these baffles as they
need to be 1/4 inch thick insulation.
There is no need to make your sec height
adjustable. I've fully explored this years
ago. Just start the sec winding at a location
that will be 2.25 inches above the even plane of
the primary and you will have the best spark
with no racing spark problems. Wind your coil
with #26 AWG wire and use a height/OD ratio of 5:1 for a nice coil.
Dr. Resonance
----- Original Message ----- From: "Tesla list" <tesla@xxxxxxxxxx>
To: <tesla@xxxxxxxxxx>
Sent: Tuesday, April 25, 2006 4:27 PM
Subject: Baffles
Original poster: "Rich" <rdjmgmt@xxxxxxxxxx>
I am getting ready to build my next coil.
Secondary form is 6 id drain pipe. I just
completed a winder setup (and yes it will be left
to right). It has two brush coats of polyurethane
on the out side it and now is setting on end with
a 100w bulb in it to make sure it is dry before I
spray the inside. A note a few days ago Dr. R
said to be sure and install a baffle about 5"
inside the tube and seal with RTV. I have a 6mm
Lexan plug at the top for torrid mount with a ¼
hole in it and a Lexan plug backed up by a Lexan
plate at the bottom, both vented, so I can mount
the secondary with nylon threaded stock to adjust
height if needed. This assembly will slide down
through the plywood that the primary is mounted
on. The primary is above the plywood by 1.5"
Do I still need the baffles about 5 "inside the
tube and should they be vented in the center?
Rich, from the middle of Missouri