[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: half filter?? and what all I need before primary circuit
- To: tesla@xxxxxxxxxx
- Subject: Re: half filter?? and what all I need before primary circuit
- From: "Tesla list" <tesla@xxxxxxxxxx>
- Date: Wed, 12 Oct 2005 21:17:46 -0600
- Delivered-to: testla@pupman.com
- Delivered-to: tesla@pupman.com
- Old-return-path: <vardin@twfpowerelectronics.com>
- Resent-date: Wed, 12 Oct 2005 21:18:52 -0600 (MDT)
- Resent-from: tesla@xxxxxxxxxx
- Resent-message-id: <GZl-eB.A.vEE.aIdTDB@poodle>
- Resent-sender: tesla-request@xxxxxxxxxx
Original poster: "D.C. Cox" <resonance@xxxxxxxxxx>
No. Do it the right way and save your xmfr the stress. The caps are
very inexpensive, All Electronics.com --- .01 uF 10 kV. Use 4-5 in
series off each bushing to ground.
Dr. Resonance
Hi, i was wondering instead of using the entire terry filter design,
could i just use the MOV's, safety gap, and resistors, and leave
out the highly expensive caps and still get a relative ammount of
safety? if not... what is the best way to get protection for my
9KV30mA " cheaply and effectively "
what is all you need basically before you send off the power towards
the tank cap and spark gap? like filter / RF chokes / safety
gap? i am still a little confused and before i buy the parts (I am
poor) i would really like to know what all to buy. Thanks a million!
Daniel from Canada