[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: new coil/rotary spark gap
- To: tesla@xxxxxxxxxx
- Subject: Re: new coil/rotary spark gap
- From: "Tesla list" <tesla@xxxxxxxxxx>
- Date: Fri, 07 Oct 2005 15:02:44 -0600
- Delivered-to: testla@pupman.com
- Delivered-to: tesla@pupman.com
- Old-return-path: <vardin@twfpowerelectronics.com>
- Resent-date: Fri, 7 Oct 2005 15:08:39 -0600 (MDT)
- Resent-from: tesla@xxxxxxxxxx
- Resent-message-id: <SISxoC.A.tPF.WPuRDB@poodle>
- Resent-sender: tesla-request@xxxxxxxxxx
Original poster: "D.C. Cox" <resonance@xxxxxxxxxx>
At 4 inch dia a flat pri is all you need. keep sec coilform 1.5
inches away and lowest turn of sec approx 2 inches above the flat
plane of the primary coil.
Correct sec winding length for a 4 inch dia coil using 5:1 aspect
ratio would be 20 inches long. You don't need 48 inches --- too long.
Dr. Resonance
Hello all,
After a long time i have decided to build another coil, it has a 4
inch by 4 foot secondary and the primary isnt made yet. I have stuck
with static spark gaps but i want more power and have decided to go
with a rotary spark gap. I have tried 3 times but i dont have the
materials needed for a good quality set up. Does anyone have one
laying around they would be interested in selling, or making me one?
Also would a flat primary be better or would a cone shaped one. I am
farely new and only built a few coils so any help is greatly
appreciated, thanks Andrew