Re: OL-DRSSTC About "5" now...

["Tesla list" <tesla@xxxxxxxxxx>]

Original poster: Terry Fritz <vardin@xxxxxxxxxxxxxxxxxxxxxxx>

Hi  DC,

See this (2nd page) for the actual coil stuff:

http://drsstc.com/~terrell/notes/DRSSTCspecifications.pdf

I will probably be going to a 150nF 4000V cap (4 CD caps in a 2x2 
array) so the primary turns is yet to be determined.  I will just tap 
a different place on the primary as needed.  I think I need 16uH.  I 
"could" figure it out now but too lazy :o)

Cheers,

        Terry



At 03:16 AM 10/5/2005, you wrote:

> What dia and length of sec are you using? Wire gauge?
>
> Also, how many pri turns are you using?
>
> Dr. Resonance
> > Hi All,
> > I got my "care package" from DigiKey today :-)
> > I got the H-Bridge and CTs built up:
> > http://hot-streamer.com/temp/OL-DRSSTC_H-Bridge_CTs.jpg
> > It is just like my other DRSSTC H-bridge but with 24V transorbs and 
> > no gate resistors.  The "board" is real nice here too!! :-))  I 
> > don't have any extras so don't ask :o))
> > The newest "hopeful" schematic is here:
> > http://hot-streamer.com/temp/OL-DRSSTC-05.gif
> > I dropped the SIDAC voltage to 140V since the 150 volt ones fired 
> > too high.  I also added a 1M 1/2 resistor across the 1uF trigger 
> > circuit cap since it stays charged "forever" without it.  The 1.5K 
> > resistor in the trigger circuit gets to about 80-90C.  But I have 
> > the 2W version installed.  Might want to go to 5W if you don't like 
> > to burn you pinkies ;-)  The super duty resistors, I use "don't care"... >:D
> > Here is the present, but ever changing, parts list:
> > http://hot-streamer.com/temp/MasterPartsList-OL-DRSSTC.pdf
> > I did test out the trigger circuit and it works perfectly like the 
> > computer and Teccor's data sheets said it would :-))))  I just put 
> > that into a PDF since it might have many DRSSTC uses ;-)
> > http://hot-streamer.com/temp/OL-DRSSTC-Trigger.pdf
> > Cheers,
> > Terry