[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: Testing Pulse Caps
- To: tesla@xxxxxxxxxx
- Subject: Re: Testing Pulse Caps
- From: "Tesla list" <tesla@xxxxxxxxxx>
- Date: Mon, 14 Nov 2005 12:34:14 -0700
- Delivered-to: testla@pupman.com
- Delivered-to: tesla@pupman.com
- Old-return-path: <vardin@twfpowerelectronics.com>
- Resent-date: Mon, 14 Nov 2005 12:34:50 -0700 (MST)
- Resent-from: tesla@xxxxxxxxxx
- Resent-message-id: <mYEHBD.A.9sF.abOeDB@poodle>
- Resent-sender: tesla-request@xxxxxxxxxx
Original poster: DRIEBEN@xxxxxxxxxxxxxxx
Mike,
You could get some high voltage rated rectifier(s)
(they can often be found on ebay) and place in se-
ries with the HV AC output of your transformer and
then see if it will hold a charge. Be careful though
as the stored voltage of the cap is very dangerous if
not lethal. Also, it's hard on the cap to short circuit
it with a very low resistance load, so only do it once
to verify that the capacitor will indeed hold a charge
at of near its rated voltage.
David Rieben
David Rieben
----- Original Message -----
From: Tesla list <tesla@xxxxxxxxxx>
Date: Monday, November 14, 2005 12:04 pm
Subject: Testing Pulse Caps
> Original poster: "MIKE HARDY" <MHARDY@xxxxxxxxxx>
>
> It's easy enough to asure a cap is good with a meter, but how does
> one find out if a pulse cap is good near the actual high operating
> voltage it will see?
>
>
>