From: "Tesla list" <tesla@xxxxxxxxxx>
To: tesla@xxxxxxxxxx
Subject: Re: First light great.
Date: Wed, 25 May 2005 21:20:43 -0600
Original poster: "S&JY" <youngsters@xxxxxxxxxxxxxxx>
Dan,
If you have extra turns on your primary, you can reduce coupling some by
removing a few of the inside turns.
--Steve Y.
----- Original Message -----
From: "Tesla list" <tesla@xxxxxxxxxx>
To: <tesla@xxxxxxxxxx>
Sent: Wednesday, May 25, 2005 5:09 PM
Subject: Re: First light great.
> Original poster: "Daniel Koll" <dk_spl_audio@xxxxxxxxxxx>
>
> No I was not using a break out, I just attached my secondary magnet wire
to
> the bottom of the sphere using aluminum tape. Should I change
> something? I cannot change the height of my primary or secondary without
> massive reconstruction. It would take hours and hours to change now. I
> was told that the bottom of the secondary and primary should be on the
same
> plane so that is what I did. Thanks
>
> >From: "Tesla list" <tesla@xxxxxxxxxx>
> >To: tesla@xxxxxxxxxx
> >Subject: Re: First light great.
> >Date: Tue, 24 May 2005 20:47:13 -0600
> >
> >Original poster: jdwarshui@xxxxxxxxx
> >
> >Hi Daniel
> >
> >I would agree with Gary about being overcoupled but it is also likely
> >that you need to re tap your primary. We usually place our spherical
> >capacitors directly on the end of the secondary. Many coilers believe
> >that spheres are inferior to toroids but I am not convinced that this
> >is true and have never seen any evidence to support this assertion.
> >
> >Are you using a breakout on your sphere?
> >
> >Jared Dwarshuis
> >
>
>
>
>
>
>