[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Primary tubing size
- To: tesla@xxxxxxxxxx
- Subject: Primary tubing size
- From: "Tesla list" <tesla@xxxxxxxxxx>
- Date: Tue, 28 Jun 2005 11:52:08 -0600
- Delivered-to: testla@pupman.com
- Delivered-to: tesla@pupman.com
- Old-return-path: <teslalist@twfpowerelectronics.com>
- Resent-date: Tue, 28 Jun 2005 12:04:15 -0600 (MDT)
- Resent-from: tesla@xxxxxxxxxx
- Resent-message-id: <MNaDM.A.lFE.YEZwCB@poodle>
- Resent-sender: tesla-request@xxxxxxxxxx
Original poster: "Mike Knowlton" <amdx@xxxxxxxxxxx>
I'm planning the primary for my 8-1/2" x 40" secondary.
I think I'll make the primary a sloped pancake @ 25*,
Any better suggestions?
I'm considering 3/8" over 1/4" copper tubing.
Any good reason to use the larger diameter?
Turn spacing provided by 10-32 nylon screws.
Also how for should I start the inner turn from the
O.D of the secondary?
Thanks for the feedback
Step by step
Mike