[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: 6ga wire vs 1/4 tubing for 900W coil primary?
- To: tesla@xxxxxxxxxx
- Subject: Re: 6ga wire vs 1/4 tubing for 900W coil primary?
- From: "Tesla list" <tesla@xxxxxxxxxx>
- Date: Fri, 29 Jul 2005 18:46:55 -0600
- Delivered-to: testla@pupman.com
- Delivered-to: tesla@pupman.com
- In-reply-to: <19e.3861da24.301c0ade@aol.com>
- Old-return-path: <vardin@twfpowerelectronics.com>
- References: <19e.3861da24.301c0ade@aol.com>
- Resent-date: Fri, 29 Jul 2005 18:46:55 -0600 (MDT)
- Resent-from: tesla@xxxxxxxxxx
- Resent-message-id: <rz5lgD.A.7nH.-3s6CB@poodle>
- Resent-sender: tesla-request@xxxxxxxxxx
Original poster: Terry Fritz <vardin@xxxxxxxxxxxxxxxxxxxxxxx>
Hi,
Since the wire is flexible, one might be able to make a
variometer. If the last turn or so was reversed and wound in the
opposite direction, perhaps you could have a way to wrap more or less
of it in the main direction to vary the inductance.
Perhaps the outer opposing turns could be wound on a circular part
that could be rotated to wind or unwind the wire.
Or, extra wire could be spooled up and unwound off a small off-axis
spool as needed.
Just a thought,
Cheers,
Terry
At 04:42 PM 7/29/2005, you wrote:
In a message dated 7/29/05 6:13:27 P.M. Eastern Daylight Time,
tesla@xxxxxxxxxx writes:
One problem is tuning. With copper tubing you can just hook to it
anywhere with a fuse clip to tune the primary. But insulated wire
requires you to cut a lot of tap points in the insulation or just get
it right the first time.
Cheers,
Terry
Hi,
Remember, any time you change anything about the coil including
adjusting the topload height, moving the coil and/or stuff in the
room near it, you will have to do some retuning. Murphy's law
gaurantees that the new tuning point will lie just under the
insulation you haven't cut off YET. ;^))
Matt D.