[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

scan tesla questions



Original poster: Steve Ward <steve.ward@xxxxxxxxx>

Hi Terry,

Just some questions.

Firstly, where can i download the newest version of ScanTesla?

Secondly (i should have been paying more attention before).  Does
scantesla use primary feedback to do its simulations?  Or does it use
some other method for selecting the drive frequency?  This could be
very important.  Just wondering how the program works in that respect.

I have been playing with it more (its simpler than i first thought it
to be) and it made some suggestions about my BIG DRSSTC.  I followed
it "instructions" and it appeared to work quite well producing 128"
streamers and no 20A fuses blowing (run times over 1 minute).  Anyway,
im finding that scan tesla's peak current predictions for my coil are
not correct (it predicted 800A, i measured 1100A).  This might be due
to a foul Rprimary input.  This run used a K of only .13, which is a
big change for my usual K=.24 type stuff!  I think this K is too low,
though, as more simulation work shows that a K of about .17-.18 seems
to have the same SERT, same bang energy, but less primary current.

Hopefully i will get my boost converter done soon, then i can run 900V
on the bridge which should make things run better i think, provided
the 1200V IGBTs will allow for the 200V increase from 700VDC.  The
boost converter shouldnt suffer from "wimpy" line conditions either
;-).

Steve