[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: Holes in the secondary
- To: tesla@xxxxxxxxxx
- Subject: Re: Holes in the secondary
- From: "Tesla list" <tesla@xxxxxxxxxx>
- Date: Tue, 12 Jul 2005 20:00:34 -0600
- Delivered-to: testla@pupman.com
- Delivered-to: tesla@pupman.com
- Old-return-path: <teslalist@twfpowerelectronics.com>
- Resent-date: Tue, 12 Jul 2005 20:01:36 -0600 (MDT)
- Resent-from: tesla@xxxxxxxxxx
- Resent-message-id: <xs27B.A.gFB.9XH1CB@poodle>
- Resent-sender: tesla-request@xxxxxxxxxx
Original poster: "Gerry Reynolds" <gerryreynolds@xxxxxxxxxxxxx>
Hi Tim,
Let me repost this since I screwed up an edit :-((.
You're going to get a wide spread of opinions on this and a lot depends on
how hard you push you secondary. I have two holes in my acrylic form (8x36
winding). At the bottom, I did just what you are suggesting and used a
nylon screw to terminate the wiring. At the top, I ran the wire into the
center and up to a termination bolt on the end cap. I put an 1/2 inch
acrylic bulkhead about four inches below the top turn to keep arcs from
going down the tube. I only used one bulkhead so as to not trap
outgassing. I also made sure the wire inside the form did not droop below
the top turn trying to keep the wire out of high field stress
areas. Lastly, I had a corona ring two inches above the top turn so the
internal routing should be surrounded by equal potential fields. Anyway, I
have achieved 74 inch power arc with no problems with the secondary yet.
Gerry R.