[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: o-scope tuning of tesla coil?

Original poster: "Black Moon" <black_moons@xxxxxxxxxxx>

Seems to me the webserver is down.. Anyone have these pictures they could send me off list? or an alternate url?

From: "Tesla list" <tesla@xxxxxxxxxx>
To: tesla@xxxxxxxxxx
Subject: Re: o-scope tuning of tesla coil?
Date: Sat, 01 Jan 2005 21:12:11 -0700

Original poster: "Antonio Carlos M. de Queiroz" <acmdq@xxxxxxxxxx>

Tesla list wrote:
> Original poster: "Black Moon" <black_moons@xxxxxxxxxxx>
> hmm.. im not sure if this is working... even adding a few turns on the
> primary seems to have little or no effect, can't seem to get
> primary/secondary tuned quite right... anyone know how to do it with both
> secondary and primary hooked up? (osilator to primary) and what the o-scope
> pics look at diffrent tuneing levels? seems to be getting about a 10x
> voltage gain and the secondary voltage is peaking in a few cycles (7 or so)
> with high coupleing...

The most effective method, I think, is to connect in series with
the primary circuit (across the spark gap, with the power supply
disconnected) a low-frequency square wave generator, with low output
impedance. Each transition of the square wave will produce a waveform
similar to what will appear in actual operation. Look at the voltage
across the primary inductor, and when the tuning is correct you
will see complete beats:


This waveform was obtained with this setup:


You can use a signal generator (square wave) too, but you need a very
output impedance. A 1 Ohm resistor connected across the output of a 50
Ohms generator is usually enough.

Antonio Carlos M. de Queiroz