[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: The Electrum Project
- To: tesla@xxxxxxxxxx
- Subject: Re: The Electrum Project
- From: "Tesla list" <tesla@xxxxxxxxxx>
- Date: Wed, 10 Aug 2005 12:24:09 -0600
- Delivered-to: testla@pupman.com
- Delivered-to: tesla@pupman.com
- Old-return-path: <vardin@twfpowerelectronics.com>
- Resent-date: Wed, 10 Aug 2005 12:26:44 -0600 (MDT)
- Resent-from: tesla@xxxxxxxxxx
- Resent-message-id: <SLRm5.A.sbB.hbk-CB@poodle>
- Resent-sender: tesla-request@xxxxxxxxxx
Original poster: "Dmitry (father dest)" <dest@xxxxxxxxxxx>
Hello Greg.
if i`m not mistaken, about 92% of the start energy is transfered from
primary to secondary, approximately at 4 periods of Fres, and system
operates in mode 6:7 or 7:8 - is it true? what is the Q (unloaded) of
primary & secondary ?
http://www.lod.org/Projects/electrum/construction/pages/rtarygap.html
here each stationary electrode has its own insulator, but here:
http://www.lod.org/Projects/electrum/NewZealand/pages/nzrotarygap.html
are they all mounted at the same insulating rod? is bottom left
electrode the last in the chain and connected to the primary?
look here:
http://www.lod.org/Projects/electrum/NewZealand/pages/nzxmsnline.html
is the top left electrode the first in the chain & connected to the
cap? and two last electrodes at the photo are connected with the bus
(from the side)? are there only 3 buses - one at the left & 2 at the
right? and why i can`t see neither buses nor electrodes here:
http://www.lod.org/Projects/electrum/NewZealand/pages/nzgapinst.html
are they covered by something from the side?
"with 8 gap in series, the effective opening speed of the gap system
is Mach 3.2, and the total mechanical dwell time is comparable to a
single beat envelope at 38khz, with k=0.22"
ok - imagine that after 1 period of Fres electrodes will go out from
"engagement", and after another three periods they will move at approx
3-x their thickness - then summary gap length will be 6" - it should
be enough for arc disconnection, but in reality this distance would be
smaller. it`s at 350bps, and at 100 - less 2" - will be enough?
i.e. this gap is quenching by itself and it`s not neccessary to connect
other in series with it? did you try to make something similar, but
in smaller scale - ex. at 10kw? coz the disc`s diameter is too large
for me - 71cm %-)
what was the effective operating impedance of this gap (approximately)?
-----
I have run coils up to 20KW in residential neighborhoods. I have
received death threats and have had the police, fire, and department of
water and power all show up at the same time. Screw 'em all. Keep firin'.
(c) Mark Barton 29-09-95