RE: GeoTC and Spice netlists

["Tesla list" <tesla-at-pupman-dot-com>]

Original poster: "Denicolai, Marco" <Marco.Denicolai-at-tellabs-dot-com> 

Rob,

Read my email dated 10.8 on this. You need the schematic editor. Sounds
stupid but that is also capable of editing symbols and saving them into
libraries.

Regards

 > -----Original Message-----
 > From: Tesla list [mailto:tesla-at-pupman-dot-com]
 > Sent: 8. lokakuuta 2004 16:37
 > To: tesla-at-pupman-dot-com
 > Subject: Re: GeoTC and Spice netlists
 >
 > Original poster: "Rob Maas" <robm-at-nikhef.nl>
 >
 > Hello,
 >
 > I have a demo version of (OrCAD) PSpice; this program suite
 > contains a lot of (sub) programs, none of which seem to be
 > able to do anything useful with a <file>.cir file (which is a
 > text file). What particular program do I need to run a
 > simulation from a 'cir' file?
 >
 > Rob
 >
 > > > I don't know how to get it to merge an external netlist
 > with its own
 > > > self-generated one, or how to tell it the connections between the
 > > > two netlists. I'll play with it and see what I can do.
 > >
 > >Some progress, Marco has been able to load a subcircuit of Thor into
 > >Microsim and it runs fine.
 > >
 > >The subcircuit is in
 > >  http://www.abelian.demon.co.uk/tmp/thors.cir
 > >
 > >and an example top-level circuit which uses it is in
 > >  http://www.abelian.demon.co.uk/tmp/thor-test.cir
 > >
 > >which models the circuit shown in
 > >   http://www.abelian.demon.co.uk/tmp/thors.model.gif
 > >
 > >Comparison between tssp, spice, and measured waveforms for Thor base
 > >current is in
 > >
 > >  http://www.abelian.demon.co.uk/tmp/thors-dot-compare.gif
 > >
 > >Marco gets the precise same waveform from the Microsim spice.
 > ....
 >
 >
 >
 >