[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Australian aluminum wire source?

To: tesla-at-pupman-dot-com
Subject: Australian aluminum wire source?
From: "Tesla list" <tesla-at-pupman-dot-com>
Date: Sat, 22 May 2004 16:45:46 -0600
Resent-Date: Sat, 22 May 2004 17:11:08 -0600
Resent-From: tesla-at-pupman-dot-com
Resent-Message-ID: <0opzVB.A.tvF.K49rAB-at-poodle>
Resent-Sender: tesla-request-at-pupman-dot-com

Original poster: "Jim Lux" <jimlux-at-earthlink-dot-net> 

I have an australian acquaintance looking for aluminum wire 2-3 mm in
diameter. Here in the US it would be a matter of going to an electrical
supply place and getting AWG 10 aluminum wire (used for grounding dish
antennas and such).  Where would one find this in Australia?  I figure one
of you folks has tried making a primary or strike rail out of the stuff.

Prev by Date: Variac???
Next by Date: Re: lighting things (II) Re: No Free Energy was Re: SSTC design procedure
Prev by thread: Re: Variac???
Next by thread: RE: Australian aluminum wire source?
Index(es):
- Date
- Thread