[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: 1.75" x 6" spun aluminum toroids available

To: tesla-at-pupman-dot-com
Subject: RE: 1.75" x 6" spun aluminum toroids available
From: "Tesla list" <tesla-at-pupman-dot-com>
Date: Tue, 04 May 2004 18:28:20 -0600
Resent-Date: Tue, 4 May 2004 18:34:13 -0600
Resent-From: tesla-at-pupman-dot-com
Resent-Message-ID: <cDcmOB.A.yI.AaDmAB-at-poodle>
Resent-Sender: tesla-request-at-pupman-dot-com

Original poster: "Mark W. Stolz" <mark_w_stolz-at-hotmail-dot-com> 

A very nice looking design Aric.  I think you did an excellent job.

Mark Stolz
Pearland, TX
http://teslacoils4christ-dot-org/


>Original poster: "Rothman, Aric" <Aric.Rothman-at-Honeywell-dot-com>
>
>One of John's toroids graces my table top Minicoil.  They are extremely 
>well made.
>
>http://www.hot-streamer-dot-com/drivethru/
>
>Aric

Prev by Date: Re: Just about
Next by Date: Re: Forced Gas Quenching
Prev by thread: RE: 1.75" x 6" spun aluminum toroids available
Next by thread: Waveform Generators - Any interest in BULK board / enclosure purchase ? ? ?
Index(es):
- Date
- Thread