Re: Help! I killed my NST!

["Tesla list" <tesla-at-pupman-dot-com>]

Original poster: "Hydrogen18" <hydrogen18-at-hydrogen18-dot-com> 

"hopefully the tar will be gone by tomorrow,
 > then I can build my " pole piglet ""

wonder what the power company would think of that terminology

----- Original Message -----
From: "Tesla list" <tesla-at-pupman-dot-com>
To: <tesla-at-pupman-dot-com>
Sent: Sunday, February 29, 2004 12:34 PM
Subject: Re: Help! I killed my NST!


 > Original poster: "Jim Mitchell" <electrontube-at-sbcglobal-dot-net>
 >
 > Nah, the insulation on the windings is just fine.  I switched over to
 > kerosene because the acetone wasn't doing anything to the tar.  now the
 > kerosene on the other hand....  I rigged up a little bubbler using my air
 > compressor set on like 2psi  hopefully the tar will be gone by tomorrow,
 > then I can build my " pole piglet "
 >
 > Regards - Jim Mitchell
 > ----- Original Message -----
 > From: "Tesla list" <tesla-at-pupman-dot-com>
 > To: <tesla-at-pupman-dot-com>
 > Sent: Sunday, February 29, 2004 1:09 AM
 > Subject: Re: Help! I killed my NST!
 >
 >
 >  > Original poster: "Gerry Reynolds" <gerryreynolds-at-earthlink-dot-net>
 >  >
 >  > Hi Jim,
 >  >
 >  > Acetone is pretty nasty stuff and not knowing better, I would be
concerned
 >  > about it desolving the winding insulation.
 >  >
 >  > Gerry R
 >  >
 >  >
 >  >  > Original poster: "Jim Mitchell" <electrontube-at-sbcglobal-dot-net>
 >  >  >
 >  >  >> Now I have the whole thing dipped in acetone to dissolve the rest
of
 > the
 >  >  > asphalt.  >
 >  >
 >  >
 >