RE: secendary

["Tesla list" <tesla-at-pupman-dot-com>]

Original poster: "Tristan Steele" <ozonejunkie-at-westnet-dot-com.au> 

Hi There,

The number of turns on a given secondary is not relative to the
diameter.

The secondary should have a certain height (h) and the wire would have a
diameter (d).  The number of turns (T) in a certain height will be given
by T = h/d.

I hope this helps.

Tristan


-----Original Message-----
From: Tesla list [mailto:tesla-at-pupman-dot-com]
Sent: Monday, May 24, 2004 1:49 PM
To: tesla-at-pupman-dot-com
Subject: secendary

Original poster: Jimbo07031982-at-aol-dot-com

i am making a new secondary and was wondering if someone could give the
mathematical solution to figure out what gauge wire i should use in
order
get x amount of turns for a given diameter pipe