Re: Depotting electronic NSTs (fwd)

["Tesla list" <tesla-at-pupman-dot-com>]

Original poster: Tesla List Moderator <mod1-at-poodle.pupman-dot-com>



---------- Forwarded message ----------
Date: Sat, 17 Jul 2004 12:55:12 -0600
From: robert heidlebaugh <rheidlebaugh-at-desertgate-dot-com>
To: Tesla list <tesla-at-pupman-dot-com>
Subject: Re: Depotting electronic NSTs

Paint suppliers and (not cheep) chemical suppliers. It will not cut most
epoxi or silicon potting. For these heat and mechanical is your only choice.
    Robert   H
-- 


> From: "Tesla list" <tesla-at-pupman-dot-com>
> Date: Fri, 16 Jul 2004 08:00:08 -0600
> To: tesla-at-pupman-dot-com
> Subject: Re: Depotting electronic NSTs
> Resent-From: tesla-at-pupman-dot-com
> Resent-Date: Fri, 16 Jul 2004 08:09:35 -0600
> 
> Original poster: "mercurus2000" <mercurus2000-at-cox-dot-net>
> 
> What's a cheap source for that?
> 
> 
> ----- Original Message -----
> From: "Tesla list" <tesla-at-pupman-dot-com>
> To: <tesla-at-pupman-dot-com>
> Sent: Thursday, July 15, 2004 9:39 PM
> Subject: RE: Depotting electronic NSTs
> 
> 
>> Original poster: "Tom Luttrell PWRCOM" <tom-at-pwrcom-dot-com.au>
>> 
>> Methylene chloride should do the trick.
>> 
>>> -----Original Message-----
>>> From: Tesla list [mailto:tesla-at-pupman-dot-com]
>>> Sent: Friday, 16 July 2004 04:07
>>> To: tesla-at-pupman-dot-com
>>> Subject: Depotting electronic NSTs
>>> 
>>> Original poster: "mercurus2000" <mercurus2000-at-cox-dot-net>
>>> 
>>> Sorry that this is slightly off topic, but I was wondering
>>> what type of
>>> solvent would dissolve the high voltage potting in the
>>> electronic NSTs?
>>> I've tried soaking it in acetone, but it only melted the
>>> plastic shell.
>>> Thanks,
>>> Adam
>>> 
>>> 
>>> 
>>> 
>> 
>> 
>> 
> 
>