[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: Depotting electronic NSTs (fwd)
Original poster: Tesla List Moderator <mod1-at-poodle.pupman-dot-com>
---------- Forwarded message ----------
Date: Sat, 17 Jul 2004 00:10:29 -0700
From: mercurus2000 <mercurus2000-at-cox-dot-net>
To: Tesla list <tesla-at-pupman-dot-com>
Subject: Re: Depotting electronic NSTs
So basically I can just use varnish or paint thinner to depot a electronic
NST? I thought they were all just mostly acetone?
----- Original Message -----
From: "Tesla list" <tesla-at-pupman-dot-com>
To: <tesla-at-pupman-dot-com>
Sent: Friday, July 16, 2004 6:13 PM
Subject: Re: Depotting electronic NSTs
> Original poster: "Arpit Thomas" <arpit-at-inzo-dot-org>
>
> http://www.aerias-dot-org/kview.asp?DocId=80&spaceid=1&subid=9
> might help
>
> *********** REPLY SEPARATOR ***********
>
> On 16/07/2004 at 8:00 AM Tesla list wrote:
>
> >Original poster: "mercurus2000" <mercurus2000-at-cox-dot-net>
> >
> >What's a cheap source for that?
> >
> >
> >----- Original Message -----
> >From: "Tesla list" <tesla-at-pupman-dot-com>
> >To: <tesla-at-pupman-dot-com>
> >Sent: Thursday, July 15, 2004 9:39 PM
> >Subject: RE: Depotting electronic NSTs
> >
> >
> > > Original poster: "Tom Luttrell PWRCOM" <tom-at-pwrcom-dot-com.au>
> > >
> > > Methylene chloride should do the trick.
> > >
> > > > -----Original Message-----
> > > > From: Tesla list [mailto:tesla-at-pupman-dot-com]
> > > > Sent: Friday, 16 July 2004 04:07
> > > > To: tesla-at-pupman-dot-com
> > > > Subject: Depotting electronic NSTs
> > > >
> > > > Original poster: "mercurus2000" <mercurus2000-at-cox-dot-net>
> > > >
> > > > Sorry that this is slightly off topic, but I was wondering
> > > > what type of
> > > > solvent would dissolve the high voltage potting in the
> > > > electronic NSTs?
> > > > I've tried soaking it in acetone, but it only melted the
> > > > plastic shell.
> > > > Thanks,
> > > > Adam
> > > >
> > > >
> > > >
> > > >
> > >
> > >
> > >
>
>