Re: 50kv xfmr

["Tesla list" <tesla-at-pupman-dot-com>]

Original poster: Ben McMillen <spoonman534-at-yahoo-dot-com> 

Thanks to everyone for the feedback!

It looks like the only thing it'll be good for is Kirlian photography or a 
really slow charging source for a can cursher..

It's brand new, so I'd rather not destroy it.. it'd be nearly impossible to 
open the case without destroying the transformer (even if it isn't that 
hard, I don't want to find out)..

I've got a few mots lying around, so I think I'll use those for the jacobs 
ladder..

Coiling in Pittsburgh
- Ben McMillen



Tesla list <tesla-at-pupman-dot-com> wrote:
Original poster: "Peter Terren"

Your 50kv output with a full wave doubler (3 caps 2 diodes) means your
transformer is being multiplied by 5.6 times the AC rating (2.8 x 2). ie
the transformer is rated at 9kv AC. Hardly big by NST standards. Similarly,
my 100kv DC mobile x-ray transformer is about 17 - 18 kv AC. My dental
x-ray transformer however is (sadly, was) a true 60kv AC transformer.

Being DC, you wont be able to make a jacobs ladder unless you have a
resistor otherwise the cap discharges with a white high intensity spark then
needs time to recharge. The resistor will take a lot of the power. Uses an
NST which is intrinsically current limited.

See the resistor I use in series with my 100kv x-ray unit to limit current
and also some big sparks.
http://tesladownunder.iinet-dot-net.au/Other_HV_stuff.htm#100kV

Peter
Tesla Downunder
 > Original poster: Ben McMillen
<spoonman534-at-yahoo-dot-com>
 > I had the wonderful experience of being given a 50kV transformer..
 > The part number is HV500-502M, and the spec sheet says it'll put
 > out 50Kv with the aid of a built in full wave doubler (so it's 50Kv
 > DC)..Max output is 5mA. It's got a 500K internal bleeder, and approximate
 > output resistance is 1.2Meg ohms...
 > I'm guessing that this will have to be current limited to start, however I
 > remember hearing that HV trannys with a doubler in them don't like to be
 > shorted as it destroys the bridge. Will that be a problem here??